First, for any kind of faucet product, it is not necessary to use excessive force when switching on and off. It only needs to be twisted or turned gently. For products equipped with hoses, care should be taken to keep the hoses naturally stretched to avoid breaking.
Second, the metal hose of the shower head of the bathtub faucet should be kept in a natural stretched state. Do not coil it around the faucet when not in use. At the same time, when using or not in use, pay attention not to form a dead angle at the joint between the hose and the valve body, so as not to break or damage the hose.
Third, it occurs when the screw-stabilized rubber nozzle is not completely closed. Usually, it is because the hard debris is caught in the sealing port. It is only necessary to remove the handle, unscrew the valve cover, and the valve core to remove the impurities and install as is. OK to resume normal use.
Fourth, if the sealing nozzle of the ceramic disc valve core is not completely closed, hard debris may scratch the sealing surface or the pre-tensioning force applied to the valve core is insufficient.
Fifth, if there is a leakage at the connection part of the water nozzle, it is usually caused by the part not being tightened at the time of assembly, and it only needs to be tightened. If the amount of dripping water is equivalent to the remaining water in the mouth of the water nozzle after the water source is closed, this is normal.
There are many reasons for the deformation of the tile, including: weak resistance to deformation of the formula, difference in firing temperature, shrinkage of the upper and lower layers, walking bricks, stick deformation, late deformation, polishing, etc. Deformation cannot be completely solved, it can only be reduced!